Sraj IBRAHIM

En résumé

Entreprises

• Advanced Vision (Saudi Bin Laden Group) - BMS Engineer (Building Management Systems)

  2014 - maintenant KAIA Project (King Abdul-Aziz International Airport) – Jeddah, KSA
  The BMS system was serving for all mechanical systems which consisted of:
  - Air Handling unit
  - Chiller Systems
  - Chilled water pump system
  - Exhausts Fans, AHU, FCU, VCU, VAV and CAV
  The BMS System was able to monitor through Graphic work station.
  Duties & Responsibilities:
  Coordination with technical section, management and making work plan
  Supervision of complete project area for:
  - Programming
  - Commissioning
  - Installation
  - Structural cabling
  - Termination
  - Logic developing for DDC controller
  

• Agc ( All Generations consultant) - RF optimization/drive test Engineer

  2013 - 2014 - Perform field testing and gathering log files using drive test tools measuring the performance of signal coverage and base station sites, Analyzing drive test logs and reporting
  - Network audit(data collection, Analysis) .
  - Tracing and micro troubleshooting (GSM, WCDMA and LTE)
  - Frequency and cell Planning
  - New sites acceptance, neighbor optimization, scrambling code collisions
  - Maintaining and Improving all Radio performance KPIs (Voice and Packet)
  - End users complaints handling (Bad coverage or quality, Drop calls, etc.)
  - Monitoring and analyzing the GSM radio Network statistics on daily basis.
  - All Radio Optimization Activities that included: Physical Optimization (Antenna – Azimuth and tilt tuning),
  - HW problems handling and troubleshooting (Alarm clearing and health checks)
  - SW tools: Post processing tools (MapInfo, Actix, TEMS, NEMO, etc.)
  

• France Télécom - R&D engineer at France TELECOM

  2012 - 2012 Development of an emulation code to navigate in an air’s network, optimization of energy consumption via the routing aspects OLSR (Optimized Link State Routing) and simulation through the NS-3 simulator (Network Simulator)

• IDIL Fibres Optiques - Assistant Engineer at IDIL (FIBER OPTIC)

  Lannion 2011 - 2011 Development of a fuel injection system for a laser pulsed YAG by developing an electronic card from the detection of an optical pulse from the laser to shaping the signal using software IAR.

• Université de Limoges - Projet académique

  Limoges 2010 - 2010 Principe de fonctionnement, Caractéristique électrique et schéma équivalent, Simulation et exploitations des résultats en variant les paramètres de la cellule, réalisation et fabrication d’une cellule photovoltaïque optimisée à haut rendement
  

• Agc ( all generations consultant) - Training Drive test engineer

  2009 - 2009 General study of GSM 2G/3G networks using telecom tools called Tems and monitor the performance of the network in several areas (TEST DRIVE)

• OGERO - Training at the Lebanese Ministry of Communications OGERO

  2008 - 2008 - PSTN Networks
  - Cabling systems
  - Transmission systems (SDH/PDH)
  - Fiber optics
  - Wi-Fi
  - WiMax
  - Proxy server (cache)
  - WAN/LAN
  - Router's configuration
  

Formations

• ENIB Ecole Nationale Des Ingénieurs De Brest (Plouzane)

  Plouzane 2010 - 2012 Ingénieur généraliste

• Université Limoges

  Limoges 2009 - 2010 Master 1

• Lebanese University (Beirut)

  Beirut 2006 - 2009 License

• Collège Universel De Marj-Ali (Shhim)

  Shhim 2005 - 2006 Baccalauréat
  
  série scientifique - sciences générales

Réseau

• Amandine MINARD

• Delphine BRIMONT (BOUDAUD)

• Dimitri ROUIL

• Fabrice CLERC

• Magali HALIN

• Ponhak-Vadh THONG

• Rabih YAKHNI

• Social TECHNET

• Thierry ARMILHON